5 Troubleshooting Techniques For Furnace Failure

During the winter, you’ll always want to come home to a warm and welcoming environment. Furnaces, like all other electrical equipment, suffer from wear and tear due to frequent use. They frequently work throughout the winter months to keep you warm and comfortable inside your home, so it’s only normal that they could develop issues that cause them to stop operating. You may need to troubleshoot your furnace if it is not keeping your house warm enough.

Here are the five techniques you can try to troubleshoot your furnace if it fails to give you enough heat.

1. Check the Filter

The air filter should be the first thing you should inspect. Filters in furnaces become filthy over time. Dirt and dust may quickly clog the filter, obstructing circulation, lowering indoor air quality, and eventually preventing the heater from turning on. Due to excessive dust and filth, it can catch fire and can cause early breakdowns. To solve this issue turn off your thermostat and make sure the electricity is turned off. Place your furnace filter in front of bright light. If you can no longer see the light through it, it’s time to get a new one. When installing a new furnace filter, double-check that the arrows are pointing in the right way. You must call a professional for furnace installation in Las Vegas.

2. Check the Thermostat

Make sure your thermostat is set to the proper temperature, which should be at least 5 degrees above room temperature. It may be necessary to replace the batteries in your thermostat, depending on how it is operated. Replace the battery, raise the temperature or setting, and wait for the system to light up. If you have an electromechanical thermostat, you may need to open it up and dust it lightly. Brush off dirt and dust using a delicate paintbrush, paying special attention to the metal coils and contact plates.

3. Check the Electrical Panel and the Furnace Switch

The filter and thermostat are sometimes fine. It’s possible that power is the issue. Examine the furnace switch, which is positioned next to the furnace. Maybe the switch was turned off by accident. Attempt to turn it back on. If that doesn’t work, go to the power outlet. Check to see if the breaker or fuse box is switched on. Make sure the HVAC breaker is turned on.

4. Check the Furnace Flame

The flame in your furnace should be a bright blue with a little yellowish tip. The blue flame signifies that your gas furnace safely and effectively burns the fuel. Remove the furnace cover panel to expose the burner assembly and pilot to verify the color of the flame. Contact a specialist for furnace cleaning in las vegas immediately once if the flame is red, yellow, purple, green, or any other hue other than blue. You should never try to change the color of your furnace’s flame on your own.

5. Check the Vents

Your furnace may be operating normally, but airflow in your home has been limited or stopped in some areas. Check that the supply and return grills are open, unobstructed, and unclogged in each room of the house. Make sure there are no obstructions to the movement of air. Blocked vents not only damage your comfort, but they may also cause duct leaks owing to high air pressure, as well as premature HVAC repairs and breakdowns.

Even after troubleshooting your furnace is causing you problems, leaving you chilly, or causing you to have excessive utility costs, it may be time to call in the professionals for heating repair in Las Vegas. For all of your HVAC requirements, contact Chazell Air Conditioning & Heating. Call today at (702) 647-3355.